Home › Vehicle Interior › SEAT › REAR SEAT CUSHION HEATER

REAR SEAT CUSHION HEATER > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below are for the LH side.



1. REMOVE REAR NO. 1 SEAT ASSEMBLY RH
  1. Remove the rear No. 1 seat assembly (Click here).



2. REMOVE RECLINING ADJUSTER KNOB CAP RH


    B191081
  1. Using a screwdriver, detach the 3 claws and remove the reclining adjuster knob cap.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR SEAT RECLINING RELEASE LEVER


    B191083
  1. Remove the 3 screws and rear seat reclining release lever.



4. REMOVE REAR SEAT CUSHION HINGE COVER NO. 3


B191084
  1. Remove the screw.

  1. Detach the 2 claws and remove the rear seat cushion hinge cover.



5. REMOVE REAR SEAT CUSHION HINGE COVER NO. 2


B191085
  1. Remove the screw.

  1. Detach the 2 claws and remove the rear seat cushion hinge cover.



6. REMOVE REAR NO. 1 SEAT CUSHION ASSEMBLY RH


    B191090
  1. Disconnect the connector and detach the 3 clamps.

    HINT:
    If the vehicle is equipped with the seat heater system, disconnect the connector and detach the clamps.



    B191088
  1. Cut the cable tie.

  1. Disconnect the cable from the seat cushion spring.



    B191089
  1. Cut the cable tie to remove the cable from the seat cushion spring.

  1. Detach the cable clamp and remove the cable from the seat cushion spring.



    B232098
  1. Detach the 2 clamps to remove the cable from the seat cushion spring.



    B191091
  1. Remove the 2 bolts.

  1. Using a T45 "TORX" socket wrench, remove the 2 "TORX" bolts and 2 bushes. Then remove the rear No. 1 seat cushion.



7. REMOVE SEAT CUSHION COVER WITH PAD


    B200241
  1. Remove the 9 hog rings.



    B191092
  1. Detach the hooks and remove the rear seat cushion spring.



8. REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER


    B191094
  1. Remove the hog rings and separate type rear seat cushion cover.



9. REMOVE SEAT CUSHION HEATER ASSEMBLY


    B191109
  1. Cut off the tack pins which fasten the seat heater to the seat cushion cover, and then remove the seat cushion heater from the seat cushion cover.