Home › Vehicle Interior › SEAT › FRONT SEATBACK HEATER

FRONT SEATBACK HEATER > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below are for the LH side.



1. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat (Click here).



2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH


    B201567E02
  1. Apply protective tape around the cushion shield.

  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE RECLINING POWER SEAT SWITCH KNOB LH


    B201568E02
  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT SEAT CUSHION SHIELD LH


    B191013
  1. Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.

  1. Remove the 2 screws.



    B166945
  1. Remove the 3 screws.

  1. Detach the 2 claws and remove the cushion shield.

  1. Disconnect the connectors.



5. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (w/o Climate Control Seat System)


    B191250
  1. Disconnect the connector and detach the 5 clamps.



    B191259
  1. Remove the nut and front seat inner belt LH.



6. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (w/ Climate Control Seat System)


    B191251
  1. Disconnect the connector and detach the 6 clamps.



    B191259
  1. Remove the nut and front seat inner belt LH.



7. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (w/o Climate Control Seat System)


    B191253
  1. Disconnect the connector and detach the clamp.



    B191261
  1. Remove the nut and front seat inner belt RH.



8. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (w/ Climate Control Seat System)


    B191254
  1. Disconnect the connector and detach the clamp.



    B191261
  1. Remove the nut and front seat inner belt RH.



9. REMOVE FRONT SEAT CUSHION SHIELD INNER LH


    B191015
  1. Remove the screw.

  1. Detach the 2 claws and clip, and then remove the cushion shield.



10. REMOVE FRONT SEAT HEADREST SUPPORT


    B191022
  1. Remove the 3 hog rings.



    B191023
  1. Detach the hooks.



    B191024
  1. Remove the 2 hog rings and seatback cover wires.



    B191055
  1. Detach the 4 claws and remove the 2 headrest supports.



11. REMOVE SEATBACK COVER WITH PAD


    B190986
  1. Lift the seatback cover and remove the nut and seatback cover bracket from the seat frame.

  1. Lift the seatback cover and remove the 4 hog rings and seatback cover with pad.



12. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    B195620
  1. Remove the 2 hog rings and seatback cover wires.



    B165535
  1. Detach the seatback cover bracket from the seatback pad.



    B191026
  1. Remove the 2 hog rings and seatback cover from the seatback pad.



13. REMOVE FRONT SEATBACK HEATER ASSEMBLY LH


    B194830
  1. Cut off the 9 tack pins which fasten the seatback heater to the seatback cover, and then remove the seatback heater from the seatback cover.