BACK DOOR OPENER SWITCH > INSTALLATION |
| 1. INSTALL BACK DOOR OUTSIDE HANDLE |
![]() |
Install the back door outside handle with the 2 bolts.
Attach the clamp.
Connect the connector.
| 2. INSTALL BACK DOOR SERVICE HOLE COVER |
![]() |
Apply butyl tape to the door panel, then install a new back door service hole cover as shown in the illustration.
| 3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Attach the 11 clips to install the back door trim board assembly.
| 4. INSTALL BACK DOOR PULL STRAP |
![]() |
Install the back door pull strap with the bolt.
| 5. INSTALL BACK DOOR STRAP COVER |
![]() |
Attach the claw to slid the back door strap cover as shown in the illustration, and install it.
| 6. INSTALL BACK DOOR SIDE GARNISH LH |
![]() |
Attach the 3 clips to install the back door side garnish LH.
| 7. INSTALL BACK DOOR SIDE GARNISH RH |
![]() |
Attach the 2 clips to install the back door side garnish RH.
| 8. INSTALL BACK DOOR CENTER GARNISH |
![]() |
Attach the 4 clips and the claw to install the back door center garnish.
| 9. INSTALL POWER BACK DOOR ROD (w/ Power Back Door) |
![]() |
Install the power back door rod with the 2 stop rings.