Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR OPENER SWITCH

BACK DOOR OPENER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR OUTSIDE HANDLE


    B190834E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Position
    Specified Condition
    1 (+B) - 2 (E)
    Back door opener switch not pushed
    10 kΩ or higher
    1 (+B) - 2 (E)
    Back door opener switch pushed
    Below 1Ω

    If the result is not specified, replace the switch assembly.