Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. Remove the instrument panel sub-assembly (Click here).



4. REMOVE NO. 1 HEATER TO REGISTER DUCT
  1. Detach the clamp.



  1. Remove the 5 <G> or <H> screws and duct.


    B192352



5. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    B192372
  1. Remove the 2 screws.

  1. Detach the 2 clamps.

  1. Detach the 10 hooks and remove the front passenger airbag from the instrument panel.



    B192373E01
  1. Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, disconnect the 2 airbag connectors and remove the instrument panel wire.