Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


  1. Attach the 11 claws to 2 clamps and install the curtain shield airbag.


    B191428

  1. Install the 14 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    NOTICE:
    Do not twist the curtain shield airbag when installing it.

  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



2. INSTALL ROOF HEADLINING ASSEMBLY
  1. Refer to the procedures from "Install Roof Headlining Assembly" (Click here).



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).