Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE ROOF HEADLINING ASSEMBLY

HINT:
Refer to the procedures up to "Remove Roof Headlining Assembly" (Click here).



3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



  1. Remove the 14 bolts.


    B191428

  1. Detach the 11 claws and the 2 clamps and remove the curtain shield airbag.