FRONT POWER SEAT CONTROL SYSTEM (w/o Memory) > OPERATION CHECK |
| CHECK FRONT POWER SEAT FUNCTION |

Check the basic functions.
Operate the power seat switches and check to make sure that each seat function works:
| CHECK POWER SEAT MOTOR ASSEMBLY (SLIDING, FRONT VERTICAL, LIFTER, RECLINING, LUMBAR SUPPORT AND LEG SUPPORT) |
Check the PTC operation inside the power seat motor.
Choose a power seat function. Operate the power seat switch and move the seat to the farthest possible position in one direction. Keep the seat in that position for approximately 60 seconds.
Operate the power seat switch again and continue to try to move the seat in the same direction as in the previous step. Measure the time until the current is shut off (motor operation sound will stop).
After the current is shut off, release the power seat switch and wait for approximately 60 seconds.
Operate the same power seat switch and move the seat in the opposite direction. Check that the motor operates.