Home › Vehicle Exterior › MIRROR (EXT) › POWER MIRROR CONTROL SYSTEM (w/ Memory)

POWER MIRROR CONTROL SYSTEM (w/ Memory) > TERMINALS OF ECU

for Preparation Click here



CHECK OUTER MIRROR CONTROL ECU

B166573E08

  1. Disconnect the M7 ECU connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No.
    (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    M7-3 (B) - M7-9 (GND)
    R - W-B
    Battery (ECU power source)
    Always
    11 to 14 V
    M7-4 (ACC) - M7-9 (GND)
    Y - W-B
    Ignition power supply
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    M7-9 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the M7 ECU connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No.
    (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    M7-1 (MR+) - M7-9 (GND)
    P - W-B
    Mirror retract motor output (retracting)
    Mirror retract switch on (Outer rear view mirror LH is retracting)
    11 to 14 V
    M7-2 (MR-) - M7-9 (GND)
    V - W-B
    Mirror retract motor output (returning)
    Mirror retract switch off (Outer rear view mirror LH is returning)
    11 to 14 V
    M7-5 (MR+) - M7-9 (GND)
    LG - W-B
    Mirror retract motor output (retracting)
    Mirror retract switch on (Outer rear view mirror RH is retracting)
    11 to 14 V
    M7-6 (MR-) - M7-9 (GND)
    BR - W-B
    Mirror retract motor output (returning)
    Mirror retract switch off (Outer rear view mirror RH is returning)
    11 to 14 V
    M8-2 (VC) - M8-3 (E1)
    LG - BR
    Power source for mirror position sensor
    Ignition switch off during sleep mode
    Below 1 V
    Ignition switch ON
    3.5 to 5.5 V
    M8-4 (VSR) - M8-3 (E1)
    L - BR
    Vertical direction position signal
    Mirror master switch R or L
    Mirror control switch UP or DOWN
    Voltage fluctuates between 0 and 5 V
    M8-5 (HSRL) - M8-3 (E1)
    W - BR
    Horizontal direction position signal
    Mirror master switch R or L
    Mirror control switch RIGHT or LEFT
    Voltage fluctuates between 0 and 5 V
    M8-18 (M+L) - M7-9 (GND)
    P - W-B
    Mirror motor output
    Mirror master switch L, Mirror control switch off
    Below 1 V
    Mirror master switch L, Mirror control switch UP or LEFT
    Below 1 V
    Mirror master switch L, Mirror control switch DOWN or RIGHT
    11 to 14 V
    M8-19 (MHL) - M7-9 (GND)
    B - W-B
    Mirror motor output
    Mirror master switch L, Mirror control switch off
    Below 1 V
    Mirror master switch L, Mirror control switch RIGHT
    Below 1 V
    Mirror master switch L, Mirror control switch LEFT
    11 to 14 V
    M8-20 (MVL) - M7-9 (GND)
    Y - W-B
    Mirror motor output
    Mirror master switch L, Mirror control switch off
    Below 1 V
    Mirror master switch L, Mirror control switch DOWN
    Below 1 V
    Mirror master switch L, Mirror control switch UP
    11 to 14 V
    M8-22 (VC) - M8-23 (E1)
    GR - BR
    Power source for mirror position sensor
    Ignition switch off during sleep mode
    Below 1 V
    Ignition switch ON
    3.5 to 5.5 V
    M8-24 (VSRR) - M8-23 (E1)
    P - BR
    Vertical direction position signal
    Mirror master switch R or L
    Mirror control switch UP or DOWN
    Voltage fluctuates between 0 and 5 V
    M8-25 (HSRR) - M8-23 (E1)
    B - BR
    Horizontal direction position signal
    Mirror master switch R or L
    Mirror control switch RIGHT or LEFT
    Voltage fluctuates between 0 and 5 V
    M8-36 (AR) - Body ground
    B - Body ground
    Reverse switch input
    Ignition switch ON, Outer mirror reverse gear link switch on
    Below 1 V
    Ignition switch ON, Outer mirror reverse gear link switch off
    11 to 14 V
    M8-38 (M+R) - M7-9 (GND)
    R - W-B
    Mirror motor output
    Mirror master switch R, Mirror control switch off
    Below 1 V
    Mirror master switch R, Mirror control switch UP or LEFT
    Below 1 V
    Mirror master switch R, Mirror control switch DOWN or RIGHT
    11 to 14 V
    M8-39 (MHR) - M7-9 (GND)
    BE - W-B
    Mirror motor output
    Mirror master switch R, Mirror control switch off
    Below 1 V
    Mirror master switch R, Mirror control switch RIGHT
    Below 1 V
    Mirror master switch R, Mirror control switch LEFT
    11 to 14 V
    M8-40 (MVR) - M7-9 (GND)
    G - W-B
    Mirror motor output
    Mirror master switch R, Mirror control switch off
    Below 1 V
    Mirror master switch R, Mirror control switch DOWN
    Below 1 V
    Mirror master switch R, Mirror control switch UP
    11 to 14 V
    If the result is not as specified, the ECU may have a malfunction.


CHECK MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

C172609E07

  1. Disconnect the DA and DD ECU connectors.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No.
    (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    DA-1 (ALTB) - Body ground
    B - Body ground
    +B power supply
    Always
    11 to 14 V
    DD-62 (GND1, GND2) - Body ground
    W-B - Body ground
    Body ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the DA and DD ECU connectors.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No.
    (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    H3-6 (RET) - DD-62 (GND1, GND2)
    V - W-B
    Mirror retract motor output (retracting)
    Mirror retract switch on
    11 to 14 V
    H3-6 (RET) - DD-62 (GND1, GND2)
    V - W-B
    Mirror retract motor output (retracting)
    Mirror retract switch off
    Below 1 V
    H4-11 (MIRB) - H4-2 (MIRE)
    R - GR
    Mirror motor output
    Mirror master switch L
    11 to 14 V
    Mirror master switch R
    11 to 14 V
    Mirror master switch off
    Below 1 V
    H4-12 (MIRS) - H4-2 (MIRE)
    L - GR
    Mirror motor output
    Mirror master switch L, Mirror control switch RIGHT
    11 to 14 V
    Mirror master switch L, Mirror control switch LEFT
    11 to 14 V
    Mirror master switch L, Mirror control switch DOWN
    11 to 14 V
    Mirror master switch L, Mirror control switch UP
    11 to 14 V
    Mirror master switch R, Mirror control switch RIGHT
    11 to 14 V
    Mirror master switch R, Mirror control switch LEFT
    11 to 14 V
    Mirror master switch R, Mirror control switch DOWN
    11 to 14 V
    Mirror master switch R, Mirror control switch UP
    11 to 14 V
    Mirror master switch off
    Below 1 V
    If the result is not as specified, the ECU may have a malfunction.