Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK COMBINATION METER

E146387E02

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    H37-1 (RHIG) - Body ground
    W - Body ground
    Power source for light control rheostat
    Ignition switch ON
    4.6 to 5.4 V
    H37-2 (TR) - Body ground
    LG - Body ground
    Light control rheostat knob input
    Light control rheostat knob fully turned downward
    Below 1 Ω
    Light control rheostat knob fully turned upward
    10 kΩ or higher
    H37-3 (E2) - Body ground
    G - Body ground
    Light control rheostat switch ground
    Always
    Below 1 Ω
    H37-5 (CHK) - Body ground
    R - Body ground
    MIL input signal
    Ignition switch ON, MIL ON
    Below 3 V
    Ignition switch ON, MIL OFF
    11 to 14 V
    H37-6 (SW) - Body ground
    Y - Body ground
    RSCA OFF indicator light input signal
    Ignition switch ON, RSCA OFF indicator light ON
    Below 1 V
    Ignition switch ON, RSCA OFF indicator light OFF
    8 to 14 V
    H37-8 (CHG-) - Body ground
    B - Body ground
    CHARGE warning light
    Ignition switch ON, CHARGE warning light ON
    Below 1 V
    Ignition switch ON, CHARGE warning light OFF
    11 to 14 V
    H37-10 (WLVL) - Body ground
    P - Body ground
    Washer level warning light
    Ignition switch ON, washer level warning light ON
    Below 1 V
    Ignition switch ON, washer level warning light OFF
    11 to 14 V
    H37-11 (S) - Body ground
    BR - Body ground
    Oil pressure warning light
    Ignition switch ON, oil pressure warning light ON
    Below 1 V
    Ignition switch ON, oil pressure warning light OFF
    11 to 14 V
    H37-12 (L) - H37-39 (E3)
    V - Y
    Fuel sender gauge
    Ignition switch ON, fuel sender gauge ON
    Below 1 V
    Ignition switch ON, fuel sender gauge OFF
    11 to 14 V
    H37-14 (SW) - Body ground
    Y - Body ground
    Brake fluid level warning light signal
    Ignition switch ON, BRAKE warning light ON
    Below 1 V
    Ignition switch ON, BRAKE warning light OFF
    11 to 14 V
    H37-16 (B) - Body ground
    B - Body ground
    Turn signal L
    Ignition switch ON, turn signal switch neutral position
    Below 1 V
    Ignition switch ON, turn signal switch turned to left
    Alternating between below 1 and 11 to 14 V
    H37-17 (B) - Body ground
    G - Body ground
    Turn signal R
    Ignition switch ON, turn signal switch neutral position
    Below 1
    Ignition switch ON, turn signal switch turned to right
    Alternating between below 1 and 11 to 14 V
    H37-18 (B) - Body ground
    LG - Body ground
    Power source
    Always
    11 to 14 V
    H37-20 (IG+) - Body ground
    P - Body ground
    Ignition switch signal
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    H37-23 (P) - Body ground
    BE - Body ground
    A/T shift position signal P
    Ignition switch ON, shift lever not in P
    Below 1 V
    Ignition switch ON, shift lever in P
    11 to 14 V
    H37-24 (R) - Body ground
    V - Body ground
    A/T shift position signal R
    Ignition switch ON, shift lever not in R
    Below 1 V
    Ignition switch ON, shift lever in R
    11 to 14 V
    H37-25 (N) - Body ground
    L - Body ground
    A/T shift position signal N
    Ignition switch ON, shift lever not in N
    Below 1 V
    Ignition switch ON, shift lever in N
    11 to 14 V
    H37-26 (D) - Body ground
    G - Body ground
    A/T shift position signal D
    Ignition switch ON, shift lever not in D
    Below 1 V
    Ignition switch ON, shift lever in D
    11 to 14 V
    H37-27 (4) - Body ground
    P - Body ground
    A/T shift position signal S
    Ignition switch ON, shift lever not in S
    Below 1 V
    Ignition switch ON, shift lever in S
    11 to 14 V
    H37-28 (A/B) - Body ground
    R - Body ground
    Drive monitor switch (INFO) signal
    Ignition switch ON, drive monitor switch (INFO) OFF
    10 kΩ or higher
    Ignition switch ON, drive monitor switch (INFO) ON
    Below 1 Ω
    H37-29 (E) - Body ground
    BE - Body ground
    Drive monitor switch (SETUP US/M) signal
    Ignition switch ON, drive monitor switch (SETUP US/M) OFF
    10 kΩ or higher
    Ignition switch ON, drive monitor switch (SETUP US/M) OFF
    Below 1 Ω
    H37-30 (RSET) - Body ground
    L - Body ground
    Drive monitor switch (SELECT RESET) signal
    Ignition switch ON, drive monitor switch (SELECT RESET) OFF
    10 kΩ or higher
    Ignition switch ON, drive monitor switch (SELECT RESET) ON
    Below 1 Ω
    H37-31 (TX+) - Body ground
    Y - Body ground
    Accessory meter input signal
    Ignition switch ON
    10 kΩ or higher
    H37-35 (+S) - Body ground
    V - Body ground
    Speed signal (output)
    Ignition switch ON, wheel turned slowly
    Pulse generation
    H37-36 (SI) - Body ground
    GR - Body ground
    Speed signal (input)
    Ignition switch ON, wheel turned slowly
    Pulse generation
    H37-37 (ILL-) - Body ground
    R - Body ground
    Illumination ground
    Always
    Below 1 Ω
    H37-38 (TC)* - Body ground
    SB - Body ground
    TAIL cancel switch signal
    TAIL cancel switch OFF
    10 kΩ or higher
    TAIL cancel switch ON
    Below 1 Ω
    H37-39 (E3) - Body ground
    Y - Body ground
    Fuel sender gauge ground
    Always
    Below 1 Ω
    H37-40 (E1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

    1. *: w/ TAIL cancel switch


CHECK ACCESSORY METER

E147619E02

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    I22-3 (RR)* - Body ground
    W - Body ground
    Ultrasonic sensor (for rear corner RH)
    Clearance warning indicator LED for rear corner RH illuminates
    Below 3 V
    I22-4 (FR)* - Body ground
    Y - Body ground
    Ultrasonic sensor (for front corner RH)
    Clearance warning indicator LED for front corner RH illuminates
    Below 3 V
    I22-5 (BK)* - Body ground
    BE - Body ground
    Ultrasonic sensor (for rear corner LH and RH)
    Clearance warning indicator LED for back right and left sensor illuminates
    Below 3 V
    I22-6 (OP)* - Body ground
    P - Body ground
    Clearance warning ECU signal
    Clearance warning indicator's operation indicator illuminates
    Below 3 V
    I22-7 (RL)* - Body ground
    GR - Body ground
    Ultrasonic sensor (for rear corner LH)
    Clearance warning indicator LED for rear corner LH illuminates
    Below 3 V
    I22-8 (FL)* - Body ground
    LG - Body ground
    Ultrasonic sensor (for front corner LH)
    Clearance warning indicator LED for front corner LH illuminates
    Below 3 V
    I22-10 (TX-) - Body ground
    V - Body ground
    Cruise information signal
    Cruise information displays
    Communication signal
    I22-11 (BZ)* - Body ground
    L - Body ground
    Clearance warning buzzer
    Clearance warning buzzer sounding (when the back sonar or clearance sonar senses something)
    Pulse generation
    I22-12 (E) - Body ground
    W-B - Body ground
    ECU ground
    Always
    Below 1 Ω
    I22-16 (MHTR) - Body ground
    BR - Body ground
    Security indicator signal
    Security indicator illuminates (illuminates only for 60 sec. in alarm sounding states (blinks when system is in armed state))
    3 to 5 V
    I22-17 (LP) - Body ground
    V - Body ground
    Security indicator light signal
    Immobiliser set status (SET)
    Alternating between 11 to 14 V and below 1 V
    Immobiliser set status (UNSET)
    Below 1 V
    I22-20 (ILL-) - Body ground
    B - Body ground
    Illumination signal
    Ignition switch ON
    11 to 14 V
    I22-21 (ILL+) - Body ground
    BE - Body ground
    Illumination signal
    Headlight dimmer switch ON
    11 to 14 V
    I22-22 (ACC) - Body ground
    GR - Body ground
    ACC power source
    Ignition switch ACC
    11 to 14 V
    I22-23 (IG) - Body ground
    G - Body ground
    IG power source
    Ignition switch ON
    11 to 14 V
    I22-24 (B) - Body ground
    R - Body ground
    +B power source
    Always
    11 to 14 V

    1. *: w/ TOYOTA Parking Assist-sensor System


CHECK COMBINATION METER INNER CIRCUIT

E162484E01


E162485E03


E181397E01


E162487E02


E162488E03


E162489E01


E162490E02


E182133E01


E162487E03


E162491E03