METER / GAUGE SYSTEM > CUSTOMIZE PARAMETERS |
| CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Customize Setting / Warning.
Select the setting by referring to the table below.
| Display (Item) | Default | Content | Setting |
| Key Remind Volume | Large | To change volume of key reminder buzzer | Large/Small/Medium |
| Key Remind Sound | Slow | To change frequency of key reminder buzzer | Normal/Slow/Fast |
| Driver Side Seatbelt Warning Buzzer | ON | To change setting of driver side seat belt warning buzzer | ON/OFF |
| Front Passenger Side Seatbelt Warning Buzzer | ON | To change setting of passenger side seat belt warning buzzer | ON/OFF |
| CUSTOMIZING FUNCTION WITH MULTI-INFORMATION DISPLAY (w/ Multi-information Display) |
Using the SETUP switch and SELECT switch, the following functions can be customized through the multi-information display. Refer to the illustration below.


