SEAT BELT WARNING SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Passenger Classification | Passenger classification: NG: Data is not determined OFF: Vacant Child: Child (less than 36 kg [79.37 lb]) is seated AF05: Adult (36 to 54 kg [79.37 to 119.05 lb]) is seated AM50: Adult (more than 54 kg [119.05 lb]) is seated Fail: A failure is detected | OFF, Child, AF05 or AM50 | - |
| Driver Buckle SW | Driver seat belt buckle switch Unset: Driver seat belt is unfastened Set: Driver seat belt is fastened NG: Data is not determined | Unset or Set | - |
| Passenger Buckle SW | Front passenger seat belt buckle switch: Unset: Front passenger seat belt is unfastened Set: Front passenger seat belt is fastened NG: Data is not determined | Unset or Set | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Passenger Buckle SW | Front passenger seat belt buckle switch: Unset: Front passenger seat belt is unfastened Set: Front passenger seat belt is fastened NG: Data is not determined | Unset or Set | - |
| Passenger Classification | Passenger classification: NG: Data is not determined OFF: Vacant Child: Child (less than 36 kg [79.37 lb]) is seated AF05: Adult (36 to 54 kg [79.37 to 119.05 lb]) is seated AM50: Adult (more than 54 kg [119.05 lb]) is seated Fail: A failure is detected | OFF, Child, AF05 or AM50 | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| P-Seatbelt Warning Buzzer | Front passenger seat belt warning buzzer: ON: Front passenger seat belt warning buzzer on setting OFF: Front passenger seat belt warning buzzer off setting | ON or OFF | - |
| PERFORM ACTIVE TEST |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
According to the display on the intelligent tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Driver Side Seat Belt | Driver side seat belt warning light | Driver side seat belt warning light is on or off | Confirm that the vehicle is stopped, engine idling |
| Front Passenger Side Seat Belt | Front passenger side seat belt warning light | Front passenger side seat belt warning light is on or off | Confirm that the vehicle is stopped, engine idling |