Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Tachometer Malfunction

for Preparation Click here


DESCRIPTION

The combination meter receives engine revolution signals from the ECM via the CAN line. The combination meter displays engine revolution data that is calculated based on the data received from the ECM.

WIRING DIAGRAM


E140490E22


INSPECTION PROCEDURE

1.CHECK DTC
  1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).
    Result 
    Result
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (TACHOMETER)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Combination Meter / Active Test.

  1. According to the display on the intelligent tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Tacho Meter Operation
    Tachometer
    0, 1000, 2000, 3000, 4000, 5000, 6000 or 7000
    -

    OK:
    Needle indication is normal.

    HINT:
    Confirm that the vehicle is stopped and engine idling.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3.READ VALUE USING INTELLIGENT TESTER (TACHOMETER)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Combination Meter / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Rpm
    Engine speed/Min.: 0, Max.: 12750
    Idling: 650 to 750
    Unit: rpm

    OK:
    Engine speed displayed on the intelligent tester is almost the same as that of the tachometer reading.



NG
Go to step 4
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)  

4.READ VALUE USING INTELLIGENT TESTER (ENGINE SPEED)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Powertrain / Engine / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Engine 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Speed
    Engine speed/Min.: 0, Max.: 16838
    Idling: 650 to 750
    Unit: rpm

    OK:
    Engine speed displayed on the intelligent tester is almost the same as that of the tachometer reading.



NG
GO TO PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)