Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Engine Coolant Temperature Gauge Malfunction

for Preparation Click here


DESCRIPTION

In this circuit, the combination meter receives the engine coolant temperature signals from the ECM using the CAN communication lines. The combination meter displays an engine coolant temperature that is calculated based on the data received from the ECM.

WIRING DIAGRAM


E140490E23


INSPECTION PROCEDURE

1.CHECK DTC
  1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).
    Result 
    Result
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK SFI SYSTEM (ENGINE COOLANT TEMPERATURE)
  1. Check for DTCs (Click here).



B
GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)