Home › Vehicle Interior › LIGHTING (INT) › GLOVE BOX LIGHT

GLOVE BOX LIGHT > INSPECTION

for Preparation Click here



1. INSPECT GLOVE BOX LIGHT ASSEMBLY


    E146129E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    10 kΩ or higher
    1 - 2
    Not pushed
    Below 1 Ω

    If the result is not as specified, replace the light assembly.