Home › Vehicle Interior › LIGHTING (INT) › GLOVE BOX LIGHT

GLOVE BOX LIGHT > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE RH


    B190151
  1. Detach the 9 claws and remove the scuff plate.



2. REMOVE COWL SIDE TRIM BOARD RH


    B190152
  1. Remove the clip.

  1. Detach the 2 clips and remove the cowl side trim board.



3. REMOVE INSTRUMENT SIDE PANEL RH


    B229197
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B226758
  1. Detach the clip and 4 claws.

  1. Detach the 2 guides and remove the under cover.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


B226741
  1. Remove the bolt <A> and 3 <D> screws.

  1. Detach the 3 claws and remove the finish panel.



    B230430
  1. Disconnect the connector.



6. REMOVE GLOVE BOX LIGHT ASSEMBLY


    E161851
  1. Detach the 2 claws and remove the glove box light.

  1. Disconnect the connector.



7. REMOVE GLOVE BOX BULB


    E161852
  1. Remove the glove box bulb.