GLOVE BOX LIGHT > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE RH |
![]() |
Detach the 9 claws and remove the scuff plate.
| 2. REMOVE COWL SIDE TRIM BOARD RH |
![]() |
Remove the clip.
Detach the 2 clips and remove the cowl side trim board.
| 3. REMOVE INSTRUMENT SIDE PANEL RH |
![]() |
Using a moulding remover, detach the 6 claws and remove the side panel.
| 4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() |
Detach the clip and 4 claws.
Detach the 2 guides and remove the under cover.
| 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH |
![]() |
Remove the bolt <A> and 3 <D> screws.
Detach the 3 claws and remove the finish panel.
![]() |
Disconnect the connector.
| 6. REMOVE GLOVE BOX LIGHT ASSEMBLY |
![]() |
Detach the 2 claws and remove the glove box light.
Disconnect the connector.
| 7. REMOVE GLOVE BOX BULB |
![]() |
Remove the glove box bulb.