Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Hazard Warning Switch Circuit

for Preparation Click here


DESCRIPTION

The turn signal flasher receives a hazard warning signal switch information signal, and illuminates the turn signal lights.

WIRING DIAGRAM


E146720E05


INSPECTION PROCEDURE

1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
E143366E06
  1. Remove the hazard warning signal switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (E) - 4 (B1)
    Hazard warning switch ON
    Below 1 Ω
    Hazard warning switch OFF
    10 kΩ or higher

  1. Reinstall the hazard warning switch assembly.



NG
REPLACE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH - TURN SIGNAL FLASHER AND BODY GROUND)
E146721E03
  1. Disconnect the J3 hazard warning signal switch assembly connector.

  1. Disconnect the H39 turn signal flasher assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection
Condition
Specified Condition
J3-4 (B1) - H39-12 (HAZ)
Always
Below 1 Ω
J3-1 (E) - Body ground
Always
Below 1 Ω
J3-4 (B1) - Body ground
Always
10 kΩ or higher

  1. Reconnect the turn signal flasher assembly connector.

  1. Reconnect the hazard warning signal switch assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)