LIGHTING SYSTEM > Turn Signal Light Circuit |

| 1.CHECK TURN SIGNAL LIGHT |
Check that the turn signal lights blink.
| Result | Proceed to |
| All turn signal lights do not blink | A |
| Only front turn signal light does not blink | B |
| Only rear combination light does not blink | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT FUSE (LH-IG, TURN-HAZ) |
![]() |
Remove the LH-IG fuse from the main body ECU.
Remove the TURN-HAZ fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| LH-IG fuse | Always | Below 1 Ω |
| TURN-HAZ fuse | Always | Below 1 Ω |
Reinstall the LH-IG and TURN-HAZ fuses.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TURN SIGNAL FLASHER - BATTERY, IGNITION SWITCH AND BODY GROUND) |
![]() |
Disconnect the H39 turn signal flasher assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H39-3 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |
| H39-1 (B) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H39-4 (E) - Body ground | Always | Below 1 Ω |
Reconnect the turn signal flasher assembly connector.
|
| ||||
| OK | ||
| ||
| 4.REPLACE FRONT TURN SIGNAL LIGHT BULB |
Temporarily replace the front turn signal light bulb with a new or normally functioning one .
Check that the front turn signal light turn on.
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (FRONT TURN SIGNAL LIGHT - TURN SIGNAL FLASHER AND BODY GROUND) |
![]() |
for LH:
Disconnect the A15 Front turn signal light LH connector.
Disconnect the H39 turn signal flasher assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A15-3 (B) - H39-10 (LTRN) | Always | Below 1 Ω |
| A15-2 (E) - Body ground | Always | Below 1 Ω |
| A15-3 (B) - Body ground | Always | 10 kΩ or higher |
Reconnect the turn signal flasher assembly connector.
Reconnect the Front turn signal light LH connector.
for RH:
Disconnect the A16 Front turn signal light RH connector.
Disconnect the H39 turn signal flasher assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A16-3 (B) - H39-17 (RTRN) | Always | Below 1 Ω |
| A16-2 (E) - Body ground | Always | Below 1 Ω |
| A16-3 (B) - Body ground | Always | 10 kΩ or higher |
Reconnect the turn signal flasher assembly connector.
Reconnect the Front turn signal light RH connector.
|
| ||||
| OK | ||
| ||
| 6.REPLACE REAR TURN SIGNAL LIGHT BULB |
Temporarily replace the rear turn signal light bulb with a new or normally functioning one .
Check that the rear turn signal light turn on.
|
| ||||
| OK | ||
| ||
| 7.CHECK HARNESS AND CONNECTOR (REAR COMBINATION LIGHT - TURN SIGNAL FLASHER AND BODY GROUND) |
![]() |
for LH:
Disconnect the O23 rear combination light assembly LH connector.
Disconnect the H39 turn signal flasher assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O23-1 (TRN) - H39-2 (LL) | Always | Below 1 Ω |
| O23-2 (E) - Body ground | Always | Below 1 Ω |
| O23-1 (TRN) - Body ground | Always | 10 kΩ or higher |
Reconnect the turn signal flasher assembly connector.
Reconnect the rear combination light assembly LH connector.
for RH:
Disconnect the O22 rear combination light assembly RH connector.
Disconnect the H39 turn signal flasher assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O22-1 (TRN) - H39-8 (LR) | Always | Below 1 Ω |
| O22-2 (E) - Body ground | Always | Below 1 Ω |
| O22-1 (TRN) - Body ground | Always | 10 kΩ or higher |
Reconnect the turn signal flasher assembly connector.
Reconnect the rear combination light assembly RH connector.
|
| ||||
| OK | ||
| ||