FRONT DOOR LOCK > INSTALLATION |
| 1. INSTALL FRONT DOOR LOCK |
Apply MP grease to the sliding and rotating areas of the front door lock.
![]() |
Install the front door inside locking cable.
![]() |
Attach the 3 claws to close the cover.
![]() |
Install the front door lock remote control cable.
Install a new door lock wire harness seal on to the front door lock.
Insert the front door lock open rod into the front door lock, and set it to the front door outside handle frame.
Make sure that the front door lock open rod is securely connected to the front door lock.
Apply adhesive to the threads of the screws.
![]() |
Using a T30 "TORX" socket wrench, install the front door lock with the 3 screws.
| 2. INSTALL FRONT DOOR FRAME REAR LOWER SUB-ASSEMBLY |
![]() |
Install the front door frame rear lower sub-assembly with the 2 bolts.
| 3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY |
![]() |
Insert the door glass into the door panel by the arrows in the illustration.
![]() |
Install the front door glass onto the front door window regulator with the 2 bolts.
| 4. INSTALL FRONT DOOR GLASS RUN |
![]() |
Install the front door glass run.
| 5. INSTALL FRONT DOOR SERVICE HOLE COVER |
![]() |
Apply butyl tape to the door panel, then install a new front door service hole cover as shown in the illustration.
![]() |
Attach the clamps and connect the connectors.
| 6. INSTALL FRONT DOOR TRIM NO. 1 BRACKET |
![]() |
Install the front door No. 1 trim bracket with the 2 screws.
| 7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
Connect the connectors.
![]() |
Connect the front door lock remote control cable and the front door inside locking cable.
![]() |
Attach the 10 clips to install the front door trim board sub-assembly.
![]() |
Tighten the 2 screws.
Install the front door armrest cover.
| 8. INSTALL FRONT ARMREST BASE UPPER PANEL |
![]() |
Connect the connector.
Attach the 2 clips and 5 claws to install the front armrest base upper panel.
| 9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG |
![]() |
Attach the 4 claws to install the front door inside handle bezel plug
| 10. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH |
![]() |
Attach the 3 clips to install the front door lower frame bracket garnish.
| 11. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers) |
![]() |
Connect the connector.
Attach the 3 clips to install the front door lower frame bracket garnish.