Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK

FRONT DOOR LOCK > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is the LH side.



1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH


    B194240
  1. Detach the 3 clips and remove the front door lower frame bracket garnish.



2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers)


    B190538
  1. Detach the 3 clips and remove the front door lower frame bracket garnish.

  1. Disconnect the connector.



3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B190539
  1. Using a moulding remover, detach the 4 claws and remove the front door inside handle bezel plug.



4. REMOVE FRONT ARMREST BASE UPPER PANEL


    B190537
  1. Detach the 2 clips and 5 claws and remove the front armrest base upper panel.

  1. Disconnect the connector.



5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


B190541
  1. Remove the front door armrest cover.

  1. Remove the 2 screws.



    B190542
  1. Detach the 10 clips.

  1. Disconnect the connector.



    B190543
  1. Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board sub-assembly.



6. REMOVE FRONT DOOR TRIM NO. 1 BRACKET


    B190549
  1. Remove the 2 screws and remove the front door No. 1 trim bracket.



7. REMOVE FRONT DOOR SERVICE HOLE COVER


    B190551
  1. Disconnect the connectors and detach the clamps.



    B195025
  1. Remove the front door service hole cover.

    NOTICE:
    Remove any tape remaining on the door side.



8. REMOVE FRONT DOOR GLASS RUN


    B190552
  1. Remove the front door glass run.



9. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY


B190553
  1. Provisionally install the power window switch.

  1. Move the front door glass until the 2 bolts can be seen through the service holes.

  1. Remove the 2 bolts.

    NOTICE:
    Do not drop or damage the front door glass subassembly when removing the bolts.



    B195026
  1. Remove the front door glass sub-assembly in the direction indicated by the arrows in the illustration.

    NOTICE:
    Do not damage the front door glass subassembly.

  1. Remove the power window switch.



10. REMOVE FRONT DOOR FRAME REAR LOWER SUB-ASSEMBLY


    B190556
  1. Remove the 2 bolts and remove the front door frame rear lower sub-assembly.

    NOTICE:
    Do not drop or damage the front door frame rear lower sub-assembly when removing the bolt.



11. REMOVE FRONT DOOR LOCK


    B190561
  1. Using a T30 "TORX" socket wrench, remove the 3 screws.

  1. Slide the front door lock downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock and cables as a unit.

  1. Remove the door lock wire harness seal from the front door lock.



    B192551
  1. Remove the front door lock remote control cable.



    B192552E01
  1. Using a screwdriver with its tip wrapped in protective tape, detach the 3 claws and open the cover.



    B192554
  1. Remove the front door inside locking cable.