Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK

REAR DOOR LOCK > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR DOOR FRAME GARNISH


    B190577
  1. Detach the 6 clips and remove the rear door frame garnish.



2. REMOVE REAR DOOR ARMREST BASE UPPER PANEL


    B190574
  1. Detach the 2 clips and 5 claws and remove the rear door armrest base upper panel.



3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


    B190575
  1. Using a moulding remover, detach the 4 claws and remove the rear door inside handle bezel plug.



4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


B190578
  1. Remove the rear door armrest cover.

  1. Remove the 2 screws.



    B190579
  1. Detach the 9 clips.

  1. Disconnect the connector.



    B190580
  1. Disconnect the rear door lock remote control cable and the rear door inside locking cable and remove the rear door trim board sub-assembly.



5. REMOVE REAR DOOR TRIM NO. 2 BRACKET


    B190583
  1. Remove the 2 screws and remove the rear door trim No. 2 bracket.



6. REMOVE REAR DOOR SERVICE HOLE COVER


    B190584
  1. Detach the clamps and disconnect the connectors.



    B195023
  1. Remove the rear door service hole cover.

    NOTICE:
    Remove any tape remaining on the door.



7. REMOVE REAR DOOR GLASS RUN


    B190585
  1. Remove the rear door glass run.



8. REMOVE REAR DOOR WINDOW FRAME REAR LOWER SUB-ASSEMBLY


    B190586E01
  1. Loosen nut A.

  1. Remove the 3 bolts and rear door window frame rear lower sub-assembly.

    NOTICE:
    Do not drop or damage the rear door window frame rear lower sub-assembly.



9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY


B190588
  1. Provisionally install the power window switch.

  1. Move the rear door glass until the 2 bolts can be seen through the service holes.

  1. Remove the 2 bolts and remove the rear door glass sub-assembly.

    NOTICE:
    Do not damage the door glass.



10. REMOVE REAR DOOR LOCK


    B192117
  1. Using a T30 "TORX" socket wrench, remove the 3 screws.

  1. Move the rear door lock downward and pull the release plate out of the rear door outside handle frame.

  1. Remove the door lock wire harness seal from the rear door lock.



    B192545E01
  1. Using a screwdriver with its tip wrapped in protective tape, detach the claw and open the cover.



    B192547
  1. Remove the rear door lock remote control cable.



    B192548E01
  1. Using a screwdriver with its tip wrapped in protective tape, detach the 3 claws and open the cover.



    B192550
  1. Remove the rear door inside locking cable.