Home › Vehicle Interior › DOOR LOCK › UNLOCK WARNING SWITCH

UNLOCK WARNING SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL UNLOCK WARNING SWITCH


    B192533
  1. Attach the 2 claws to install the unlock warning switch.

  1. Connect the connector.



2. INSTALL UPPER STEERING COLUMN COVER


    E146420
  1. Attach the 4 clips to install the upper steering column cover onto the instrument panel cluster finish panel.

  1. Attach the claw to install the upper steering column cover.



3. INSTALL LOWER STEERING COLUMN COVER


    E146419
  1. Attach the 2 claws to install the lower steering column cover.

    NOTICE:
    Do not damage the tilt and telescopic switch.

  1. While turning the steering wheel to the right and left, install the 2 screws and the lower steering column cover.



4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Attach the 2 claws to install the sensor.

  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 <A> bolts.



5. INSTALL INSTRUMENT SIDE PANEL LH


    B229058
  1. Attach the 7 claws to install the side panel.



6. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



7. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.