Home › Vehicle Interior › DOOR LOCK › UNLOCK WARNING SWITCH

UNLOCK WARNING SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



2. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



3. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B229064
  1. Remove the 2 <A> bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



5. REMOVE LOWER STEERING COLUMN COVER
  1. Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully extend and lower the steering column.



    E146419
  1. While turning the steering wheel to the right and left, remove the 2 screws and the lower steering column cover.

  1. Detach the 2 claws to remove the lower steering column cover.

    NOTICE:
    Do not damage the tilt and telescopic switch.



6. REMOVE UPPER STEERING COLUMN COVER


    E146420
  1. Detach the 4 clips.

  1. Detach the claw to remove the upper steering column cover.



7. REMOVE UNLOCK WARNING SWITCH
  1. Disconnect the connector.

  1. Insert the key into the ignition key cylinder.



    B192532E01
  1. Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the unlock warning switch.