STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) > INSTALLATION |
| 1. INSTALL STEERING COLUMN ASSEMBLY |
![]() |
Install the steering column with the bolt and 2 nuts.
Connect the connectors and wire harness clamps.
| 2. INSTALL NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY |
![]() |
Align the matchmarks on the No. 2 steering intermediate shaft and power steering gear.
Install the bolt.
| 3. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY |
![]() |
Align the matchmarks on the steering intermediate shaft and No. 2 steering intermediate shaft.
Install the bolt.
![]() |
Align the matchmarks on the steering column and steering intermediate shaft.
Install the bolt.
![]() |
Install the 3 bolts and nut.
| 4. INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY |
![]() |
Install the air duct with the bolt.
| 5. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY |
![]() |
Connect the connector.
Attach the 2 claws to install the DLC3.
Install the 4 bolts to install the instrument panel airbag.
| 6. INSTALL INSTRUMENT SIDE PANEL LH |
![]() |
Attach the 7 claws to install the side panel.
| 7. INSTALL COWL SIDE TRIM BOARD LH |
| 8. INSTALL FRONT DOOR SCUFF PLATE LH |
| 9. INSTALL COMBINATION SWITCH |
![]() |
Install the turn signal switch with spiral cable to the steering column with the clamp.
![]() |
Connect the 6 connectors to the turn signal switch with spiral cable.
| 10. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Attach the claw to install the upper steering column cover.
Attach the 4 clips.
| 11. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Attach the 2 claws to install the lower steering column cover.
Install the 2 screws.
| 12. ADJUST SPIRAL CABLE |
![]() |
Check that the ignition switch is off.
Check that the battery negative (-) terminal is disconnected.
Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.
![]() |
Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.
| 13. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and steering main shaft.
Install the steering wheel set nut.
| 14. INSPECT STEERING WHEEL CENTER POINT |
| 15. INSTALL STEERING PAD |
![]() |
Check that the ignition switch is turned off.
Check that the negative battery terminal is disconnected.
Connect the horn connector.
Connect the airbag connector.
Install the steering pad.
![]() |
Using T30 "TORX" socked wrench, tighten the 2 screws.
| 16. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 17. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 19. INSPECT SRS WARNING LIGHT |
Check the SRS warning light (Click here).
| 20. CUSTOMIZE INFORMATION |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Utility / Customize Setting / Tilt & Telescopic.
Turn the auto away/return function ON.