STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) > DISASSEMBLY |
| 1. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU |
![]() |
Disconnect the 2 ECU connectors.
Remove the 2 screws and ECU.
| 2. REMOVE TRANSPONDER KEY AMPLIFIER |
![]() |
Using a screwdriver, widen the claws attached to the upper bracket by approximately 1.0 mm (0.0394 in.).
Pull out the transponder key amplifier with the claws open.
| 3. REMOVE UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY |
Secure the steering column in a vise.
Using a center punch, mark the center of the 2 tapered-head bolts.
Using a 3 to 4 mm (0.118 to 0.157 in.) drill, drill a hole in the 2 tapered-head bolts.
![]() |
Using a screw extractor, remove the 2 tapered-head bolts, and then remove the upper steering column with switch bracket and the steering lock bracket from the steering column.
| 4. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY |
Turn the ignition switch lock cylinder to the ACC position.
![]() |
Push a screwdriver into the hole of the steering column upper with switch bracket assembly shown in the illustration and pull the ignition switch lock cylinder assembly until its claw contacts the stopper of the steering column upper with switch bracket assembly.
![]() |
Insert a screwdriver into the hole of the steering column upper with switch bracket assembly. Push the screwdriver downward as shown in the illustration to disengage the claw of the ignition switch lock cylinder assembly. Pull out the ignition switch lock cylinder assembly.
| 5. REMOVE UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Detach the 2 claws and remove the switch.
| 6. REMOVE KEY INTERLOCK SOLENOID |
![]() |
Remove the 2 screws and key interlock solenoid from the upper steering column with switch bracket assembly.
| 7. REMOVE IGNITION SWITCH ASSEMBLY |
![]() |
Detach the 2 claws and remove the ignition switch from the upper steering column with switch bracket assembly.