Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)

STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) > DISASSEMBLY

for Preparation Click here


NOTICE:
When using a vise, do not overtighten it.



1. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU


C159704
  1. Disconnect the 2 ECU connectors.

  1. Remove the 2 screws and ECU.



2. REMOVE TRANSPONDER KEY COIL


C155153
  1. Using a screwdriver, widen the claws attached to the upper bracket by approximately 1.0 mm (0.0394 in.).

  1. Pull out the transponder key coil with the claws open.

    NOTICE:
    Using excessive force may damage the case.



3. REMOVE UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY
  1. Secure the steering column in a vise.

  1. Using a center punch, mark the center of the 2 tapered-head bolts.

  1. Using a 3 to 4 mm (0.118 to 0.157 in.) drill, drill a hole in the 2 tapered-head bolts.



    C159754
  1. Using a screw extractor, remove the 2 tapered-head bolts, and then remove the upper steering column with switch bracket and the steering lock bracket from the steering column.



4. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY
  1. Turn the ignition switch lock cylinder to the ACC position.



    C105482E03
  1. Push a screwdriver into the hole of the steering column upper with switch bracket assembly shown in the illustration and pull the ignition switch lock cylinder assembly until its claw contacts the stopper of the steering column upper with switch bracket assembly.

    NOTICE:
    Make sure to pull the ignition switch lock cylinder assembly until its claw contacts the stopper of the steering column bracket assembly upper. Failure to do so will affect later work operations.



    C105483E03
  1. Insert a screwdriver into the hole of the steering column upper with switch bracket assembly. Push the screwdriver downward as shown in the illustration to disengage the claw of the ignition switch lock cylinder assembly. Pull out the ignition switch lock cylinder assembly.



5. REMOVE UNLOCK WARNING SWITCH ASSEMBLY


C155156
  1. Detach the 2 claws and remove the switch.



6. REMOVE KEY INTERLOCK SOLENOID


C155158
  1. Remove the 2 screws and key interlock solenoid from the upper steering column with switch bracket assembly.



7. REMOVE IGNITION SWITCH ASSEMBLY


C155157
  1. Detach the 2 claws and remove the ignition switch from the upper steering column with switch bracket assembly.