Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER

NAVIGATION RECEIVER > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 RADIO BRACKET


    B164794
  1. Install the bracket with the 4 bolts.

    Torque:
    4.5 N*m{ 45 kgf*cm , 39 in.*lbf }



2. INSTALL NO. 1 RADIO BRACKET


    E260242
  1. Install the bracket with the 4 bolts.

    Torque:
    4.5 N*m{ 45 kgf*cm , 39 in.*lbf }



3. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
  1. Connect the connectors.



    E260251
  1. Insert the navigation receiver as shown in the illustration to attach the 3 clips on its backside.

    NOTICE:
    When inserting the navigation receiver, do not press the knobs on it.



    E260240
  1. Install the navigation receiver with the 4 bolts.

    Torque:
    8.0 N*m{ 81 kgf*cm , 70 in.*lbf }



4. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY


    I104352
  1. Connect the connectors.

  1. Attach the 4 clips and install the panel.



5. INSTALL CENTER LOWER INSTRUMENT PANEL FINISH PANEL
  1. Connect the connectors.

  1. Attach the 4 clips and 2 claws to install the finish panel.



6. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. Attach the 12 clips to install the finish panel.

  1. Connect the 2 connectors and clamp.

  1. Attach the 4 claws to install the instrument panel finish panel retainer.



7. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


    B222976
  1. Connect the connectors.

  1. Attach the 6 clips to install the console panel.

  1. Install the clip.



8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    B161742
  1. Attach the 12 clips to install the console panel.



9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    B167312
  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



10. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Attach the 2 claws to install the sensor.

  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 <A> bolts.



11. INSTALL INSTRUMENT SIDE PANEL LH


    B229058
  1. Attach the 7 claws to install the side panel.



12. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



13. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }