Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › HARD DISK DRIVE

HARD DISK DRIVE > INSTALLATION

for Preparation Click here



1. PRECAUTION

NOTICE:
Precautions for navigation receiver assembly and hard disk drive (Click here).



2. INSTALL HARD DISK DRIVE


    E260247
  1. Insert the hard disk drive in the direction shown by the arrow in the illustration to install it.

  1. Attach the 2 guides to temporarily install the cover.

  1. Install the cover with the 2 screws.



3. INSTALL NO. 1 RADIO BRACKET


    E260242
  1. Install the bracket with the 4 bolts.

    Torque:
    4.5 N*m{ 45 kgf*cm , 39 in.*lbf }



4. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
  1. Connect the connectors.



    E260251
  1. Insert the navigation receiver as shown in the illustration to attach the 3 clips on its backside.

    NOTICE:
    When inserting the navigation receiver, do not press the knobs on it.



    E260240
  1. Install the navigation receiver with the 4 bolts.

    Torque:
    8.0 N*m{ 81 kgf*cm , 70 in.*lbf }



5. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY


    I104352
  1. Connect the connectors.

  1. Attach the 4 clips and install the panel.



6. INSTALL CENTER LOWER INSTRUMENT PANEL FINISH PANEL
  1. Connect the connectors.

  1. Attach the 4 clips and 2 claws to install the finish panel.



7. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. Attach the 12 clips to install the finish panel.

  1. Connect the 2 connectors and clamp.

  1. Attach the 4 claws to install the instrument panel finish panel retainer.



8. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


    B222976
  1. Connect the connectors.

  1. Attach the 6 clips to install the console panel.

  1. Install the clip.



9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    B161742
  1. Attach the 12 clips to install the console panel.



10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    B167312
  1. Install the shift lever knob and twist it in the direction indicated by the arrow.



11. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Attach the 2 claws to install the sensor.

  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 <A> bolts.



12. INSTALL INSTRUMENT SIDE PANEL LH


    B229058
  1. Attach the 7 claws to install the side panel.



13. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



14. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }