STEERING WHEEL > INSTALLATION |
| 1. INSTALL STEERING WHEEL PAD ATTACHING SCREW |
![]() |
Install the 2 steering wheel pad attaching screws.
| 2. INSTALL CRUISE CONTROL MAIN SWITCH |
![]() |
Install the cruise control main switch with the 2 screws.
| 3. INSTALL STEERING PAD COVER RH (w/o Steering Pad Switch) |
![]() |
Attach the 2 pins to install the steering pad cover RH with the screw.
| 4. INSTALL STEERING PAD COVER LH (w/o Steering Pad Switch) |
![]() |
Attach the 2 pins to install the steering pad cover RH with the screw.
| 5. INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch) |
![]() |
Attach the 4 pins to install the switch with the 2 screws.
Connect the connector.
| 6. ADJUST SPIRAL CABLE |
![]() |
Check that the ignition switch is off.
Check that the battery negative (-) terminal is disconnected.
Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.
![]() |
Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.
| 7. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel and steering main shaft.
Install the steering wheel set nut.
| 8. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 9. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Attach the 2 claws to install the cover.
| 10. INSTALL STEERING PAD |
![]() |
Check that the ignition switch is turned off.
Check that the negative battery terminal is disconnected.
Connect the horn connector.
Connect the airbag connector.
Install the steering pad.
![]() |
Using T30 "TORX" socked wrench, tighten the 2 screws.
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. INSPECT STEERING PAD |
| 13. INSPECT SRS WARNING LIGHT |
Inspect SRS warning light (Click here).