Home › Steering › STEERING COLUMN › STEERING WHEEL

STEERING WHEEL > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH ASSEMBLY



C205424E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A9(AU2) - A8(EAU)
    No switch is pushed
    100 kΩ or higher
    MODE switch is pushed
    Below 1 Ω
    A10(AU1) - A8(EAU)
    No switch is pushed
    100 kΩ or higher
    Seek+ switch is pushed
    Below 1 Ω
    Seek- switch is pushed
    321 to 345 Ω
    Volume+ switch is pushed
    950 to 1050 Ω
    Volume- switch is pushed
    2954 to 3265 Ω
    A3(AC1) - A2(EAC)
    No switch is pushed
    100 kΩ or higher
    Auto switch is pushed
    Below 1 Ω
    Off switch is pushed
    313 to 345 Ω
    Temp+ switch is pushed
    950 to 1050 Ω
    Temp- switch is pushed
    2955 to 3266 Ω

    If the result is not as specified, replace the steering pad switch assembly.