Home › Steering › STEERING COLUMN › STEERING WHEEL

STEERING WHEEL > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH ASSEMBLY


  1. Measure the resistance according to the value(s) in the table below.


    C290062E01


    Text in Illustration 
    *1
    Right Switch
    *2
    Up Switch
    *3
    Left Switch
    *4
    Down Switch
    *5
    Enter Switch
    *6
    Back Switch
    *7
    Mode Switch
    *8
    Volume + Switch
    *9
    Volume - Switch
    *10
    Voice Switch
    *11
    Off Hook Switch
    *12
    On Hook Switch
    *a
    Component without harness connected
    -
    -

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A10 (AU1) - A8 (EAU)
    No switch is pushed
    95 to 105 kΩ
    Up switch is pushed
    Below 2.5 Ω
    Down switch is pushed
    313 to 345 Ω
    Volume + switch is pushed
    950 to 1050 Ω
    Volume - switch is pushed
    2955 to 3265 Ω
    A8 (EAU) - A7 (AU3)
    No switch is pushed
    95 to 105 kΩ
    Right switch is pushed
    950 to 1050 Ω
    Left switch is pushed
    2955 to 3265 Ω
    Enter switch is pushed
    Below 2.5 Ω
    Back switch is pushed
    313 to 345 Ω
    A9 (AU2) - A8 (EAU)
    No switch is pushed
    95 to 105 kΩ
    Mode switch is pushed
    Below 2.5 Ω
    Off hook switch is pushed
    950 to 1050 Ω
    On hook switch is pushed
    313 to 345 Ω
    Voice switch is pushed
    2955 to 3265 Ω
    B (HO) - A1 (HO)
    Always
    Below 1 Ω

    If the result is not as specified, replace the steering pad switch assembly.

  1. Check the illumination.

    1. Connect the battery positive (+) lead to terminal A5 (IL+2) and the negative (-) lead to terminal A2 (EAC) of the steering pad switch assembly connector.

    2. Check that the switch illumination comes on.

      OK:
      Steering pad switch illumination comes on.

      If the result is not as specified, replace the steering pad switch assembly.