Home › Steering › STEERING COLUMN › STEERING WHEEL

STEERING WHEEL > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    B166432
  1. Using a screwdriver, detach the 2 claws and remove the steering wheel cover.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    B166433
  1. Using a screwdriver, detach the 2 claws and remove the steering wheel cover.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE STEERING PAD


    C180934
  1. Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

  1. Pull the steering pad toward you.



    B166581
  1. Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, disconnect the 2 connectors.

  1. Disconnect the horn connector.



5. REMOVE STEERING WHEEL ASSEMBLY


    C180956
  1. Detach the cruise control main wire harness clamp from the steering wheel side.

  1. Disconnect the steering pad switch connector and cruise control main switch connector from the spiral cable.

  1. Remove the steering wheel set nut.



    C180950E01
  1. Put matchmarks on the steering wheel and main shaft.

  1. Using SST, remove the steering wheel.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05011)



6. REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)


C180957
  1. Disconnect the connector.

  1. Remove the 2 screws.

  1. Detach the 4 pins and remove the steering pad switch.



7. REMOVE STEERING PAD COVER RH (w/o Steering Pad Switch)


    C180959
  1. Remove a screw.

  1. Detach the 2 pins and remove the steering pad cover.



8. REMOVE STEERING PAD COVER LH (w/o Steering Pad Switch)


    C180960
  1. Remove a screw.

  1. Detach the 2 pins and remove the steering pad cover.



9. REMOVE CRUISE CONTROL MAIN SWITCH


    C180958
  1. Remove the 2 screws and remove the cruise control main switch.



10. REMOVE STEERING WHEEL PAD ATTACHING SCREW


    C180961
  1. Remove the 2 steering wheel pad attaching screws.