Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER

FRONT DOOR SPEAKER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH RH


    B190538
  1. Detach the 3 clips and remove the front door lower frame bracket garnish.

  1. Disconnect the connector.



2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG RH


    B190539
  1. Using a moulding remover, detach the 4 claws and remove the front door inside handle bezel plug.



3. REMOVE FRONT UPPER ARMREST BASE PANEL RH


    B190537
  1. Detach the 2 clips and 5 claws and remove the front armrest base upper panel.

  1. Disconnect the connector.



4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH


B190541
  1. Remove the front door armrest cover.

  1. Remove the 2 screws.



    B190542
  1. Detach the 10 clips.

  1. Disconnect the connector.



    B190543
  1. Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board sub-assembly.



5. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    E161072
  1. Disconnect the speaker connector.

  1. Remove the 4 screws.



    E161076
  1. Detach the 3 claws and remove the speaker.

    NOTICE:
    Do not touch the cone part of the speaker.



6. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY (for 14 Speakers)


    B191806
  1. Detach the 3 claws and remove the speaker.

    NOTICE:
    Do not touch the cone part of the speaker.