TOYOTA PARKING ASSIST-SENSOR SYSTEM > Indicator Circuit |

| 1.INSPECT FUSE (ECU-IG No. 1) |
![]() |
Remove the ECU-IG No. 1 fuse from the cowl side junction block LH.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG No. 1 fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ACCESSORY METER ASSEMBLY - BATTERY) |
![]() |
Disconnect the I22 accessory meter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I22-23 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ACCESSORY METER ASSEMBLY - CLEARANCE WARNING ECU) |
![]() |
Disconnect the H43 clearance warning ECU connector.
Disconnect the I22 accessory meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H43-15 (L1) - I22-3 (RR) | Always | Below 1 Ω |
| H43-16 (L2) - I22-4 (FR) | ||
| H43-17 (L3) - I22-7 (RL) | ||
| H43-18 (L4) - I22-8 (FL) | ||
| H43-19 (L5) - I22-5 (BK) | ||
| H43-20 (L6) - I22-6 (OP) | ||
| H43-15 (L1) - Body ground | Always | 10 kΩ or higher |
| H43-16 (L2) - Body ground | ||
| H43-17 (L3) - Body ground | ||
| H43-18 (L4) - Body ground | ||
| H43-19 (L5) - Body ground | ||
| H43-20 (L6) - Body ground |
|
| ||||
| OK | |
| 4.REPLACE ACCESSORY METER ASSEMBLY |
Replace the accessory meter assembly with a normally functioning or new accessory meter assembly (Click here).
Check that the accessory meter indicator operates normally.
|
| ||||
| OK | ||
| ||