METER / GAUGE SYSTEM > Oil Pressure Gauge Malfunction |

| 1.CHECK DTC |
Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).
| Result | Proceed to |
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (OIL PRESSURE RECEIVER GAUGE) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
According to the display on the intelligent tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Oil Pressure Meter Operation | Oil pressure receiver gauge | LOW, 1/4, 1/2, 3/4 or HIGH | Perform the test with the vehicle stopped and engine idling |
|
| ||||
| OK | |
| 3.INSPECT OIL PRESSURE GAUGE ASSEMBLY (OIL PRESSURE SENDER GAUGE) |
![]() |
Disconnect the E13 gauge connector.
Apply battery positive (+) voltage to the sender gauge terminal through a test LED.
Check that the LED does not illuminate when the engine is stopped.
Check that the LED flashes when the engine is running. The number of flashes varies with engine speed.
| Result | Proceed to |
| LED operates correctly according to engine condition | A |
| LED does not operate correctly according to engine condition | B |
|
| ||||
| A | |
| 4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - OIL PRESSURE SENDER GAUGE) |
![]() |
Disconnect the H37 meter connector.
Disconnect the E13 gauge connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H37-11 (S) - D57-1 or E13-1 | Always | Below 1 Ω |
| H37-11 (S) - Body ground | Always | 10 kΩ or higher |
| D57-1 or E13-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||