Home › Drivetrain ยท AXLE AND DIFFERENTIAL › AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR (for 4WD)

AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR (for 4WD) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



2. REMOVE AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR


C159797
  1. Disconnect the actuator hose.

  1. Disconnect the actuator connector.

  1. Remove the 4 bolts and actuator.