RELAY > ON-VEHICLE INSPECTION |
| 1. CHECK STOP LIGHT CONTROL RELAY (BRK NO. 1, BRK NO. 2) |
Remove the 2 stop light control relays from the engine room relay block.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 4 | When battery voltage is applied to terminals 1 and 2 | 10 kΩ or higher |
| When battery voltage is not applied to terminals 1 and 2 | Below 1 Ω | |
| 3 - 5 | When battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
| When battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
Install the 2 stop light control relays.