Home › Vehicle Exterior › LIGHTING (EXT) › TURN SIGNAL FLASHER ASSEMBLY

TURN SIGNAL FLASHER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TURN SIGNAL FLASHER ASSEMBLY


    E161849
  1. Install the turn signal flasher with the nut.

  1. Connect the connector.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B163883
  1. Attach the 2 claws to install the sensor.



    B229064
  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 <A> bolts.



3. INSTALL INSTRUMENT SIDE PANEL LH


    B229058
  1. Attach the 7 claws to install the side panel.



4. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure as for the RH side .



5. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .