TURN SIGNAL FLASHER ASSEMBLY > ON-VEHICLE INSPECTION |
| 1. CHECK TURN SIGNAL FLASHER ASSEMBLY |
![]() |
Check the power source circuit and ground circuit.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (B) - 4 (E) | Always | 11 to 14 V |
| 3 (IG) - 4 (E) | Ignition switch ON | 11 to 14 V |
| 11 (+B) - 4 (E) | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4 (E) - Body ground | Always | Below 1 Ω |
Check the output operation signal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 2 (LL) - 4 (E) | Hazard warning switch OFF | Below 1 V |
| Hazard warning switch ON | 9 V or higher (60 to 120 times per minute) | |
| 6 (EL) - 4 (E) | Headlight dimmer switch (TURN L) OFF | 9 V or higher |
| Headlight dimmer switch (TURN L) ON | Below 1 V | |
| 7 (ER) - 4 (E) | Headlight dimmer switch (TURN R) OFF | 9 V or higher |
| Headlight dimmer switch (TURN R) ON | Below 1 V | |
| 8 (LR) - 4 (E) | Hazard warning switch OFF | Below 1 V |
| Hazard warning switch ON | 9 V or higher (60 to 120 times per minute) | |
| 12 (HAZ) - 4 (E) | Hazard warning switch OFF | 9 V or higher |
| Hazard warning switch ON | Below 1 V |