4WD CONTROL ECU > INSTALLATION |
| 1. INSTALL 4WD CONTROL ECU |
![]() |
Install the ECU with the bolt.
Connect the 2 ECU connectors.
| 2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH |
Connect the connector.
Attach the 3 claws to install the finish panel.
Install the 3 <D> screws and bolt <A>.
| 3. INSTALL INSTRUMENT SIDE PANEL RH |
![]() |
Attach the 6 claws to install the side panel.
| 4. INSTALL COWL SIDE TRIM BOARD RH |
![]() |
Attach the 2 clips to install the cowl side trim board.
Install the clip.
| 5. INSTALL FRONT DOOR SCUFF PLATE RH |
![]() |
Attach the 2 claws and 5 clips to install the rear door scuff plate.
Install the 2 bolts.
![]() |
Attach the 6 claws, 5 clips and 2 guides to install the rear door scuff plate.
Install the screw.