Home › Drivetrain ยท JF3A TRANSFER / 4WD / AWD › 4WD CONTROL ECU

4WD CONTROL ECU > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE RH


    B190151
  1. Detach the 9 claws and remove the scuff plate.



2. REMOVE COWL SIDE TRIM BOARD RH


    B190152
  1. Remove the clip.

  1. Detach the 2 clips and remove the cowl side trim board.



3. REMOVE INSTRUMENT SIDE PANEL RH


    B229197
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


B226741
  1. Remove the bolt <A> and 3 <D> screws.

  1. Detach the 3 claws and remove the finish panel.



    B230430
  1. Disconnect the connector.



5. REMOVE 4WD CONTROL ECU


    C160016
  1. Disconnect the 2 4WD control ECU connectors.

  1. Remove the bolt and 4WD control ECU.