AIR INJECTION DRIVER (w/ Secondary Air Injection System) > REMOVAL |
| 1. REMOVE AIR INJECTION CONTROL DRIVER ASSEMBLY |
![]() |
Disconnect the 4 air injection control driver connectors.
![]() |
Remove the bolt and disconnect the ground cable.
Disconnect the 2 wire harness clamps.
![]() |
Remove the 3 bolts and air injection control driver.
| 2. REMOVE AIR INJECTION CONTROL DRIVER (for Bank 1) |
![]() |
Remove the 2 bolts.
![]() |
Remove the 2 screws and air injection control driver.
| 3. REMOVE AIR INJECTION CONTROL DRIVER (for Bank 2) |
![]() |
Remove the 2 screws and air injection control driver.