4WD CONTROL SWITCH > ON-VEHICLE INSPECTION |
| 1. INSPECT 4WD CONTROL SWITCH |
Check the harness and connector (ECU - battery and body ground).
![]() |
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A26-3 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| A26-4 (GND) - Body ground | Always | Below 1 Ω |
Check the harness and connector (switch - ECU).
Disconnect the A25 ECU connector.
Disconnect the L1 switch connector.
Measure the resistance according to the value(s) in the table below.

| Tester Connection | Condition | Specified Condition |
| L1-2 (LO) - A25-13 (LO) | Always | Below 1 Ω |
| L1-2 (LO) - Body ground | Always | 10 kΩ or higher |
| L1-4 (GND) - Body ground | Always | Below 1 Ω |
| L1-5 (2-4) - A25-11 (2-4) | Always | Below 1 Ω |
| L1-5 (2-4) - Body ground | Always | 10 kΩ or higher |
Check the 4WD control switch.
Turn the ignition switch off.
Connect the L1 switch connector.
Connect the A25 and A26 ECU connectors.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A25-11 (2-4) - Body ground | Ignition switch ON 4WD control switch 2WD position | Below 1.5 V |
| Ignition switch ON 4WD control switch 4H position | Below 1.5 V | |
| Ignition switch ON 4WD control switch 4L position | 10.5 to 14 V | |
| A25-13 (LO) - Body ground | Ignition switch ON 4WD control switch 2WD position | 10.5 to 14 V |
| Ignition switch ON 4WD control switch 4H position | Below 1.5 V | |
| Ignition switch ON 4WD control switch 4L position | Below 1.5 V |
Check the 4WD control ECU.
Disconnect the L1 switch connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| L1-2 (LO) - Body ground | Ignition switch ON | 10.5 to 14 V |
| L1-5 (2-4) - Body ground | Ignition switch ON | 10.5 to 14 V |