LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Power Seat) > REMOVAL |
| 1. REMOVE FRONT SEAT ASSEMBLY LH |
Remove the front seat (Click here).
| 2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH |
![]() |
Apply protective tape around the cushion shield.
Using a screwdriver, detach the 2 claws and remove the knob.
| 3. REMOVE RECLINING POWER SEAT SWITCH KNOB |
![]() |
Using a screwdriver, detach the 2 claws and remove the knob.
| 4. REMOVE FRONT SEAT CUSHION SHIELD LH |
![]() |
Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.
Remove the 2 screws.
![]() |
Remove the 3 screws.
Detach the 2 claws and remove the cushion shield.
Disconnect the connectors.
| 5. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH |
![]() |
Disconnect the connector and detach the 5 clamps.
![]() |
Remove the nut and front seat inner belt LH.
| 6. REMOVE FRONT SEAT CUSHION SHIELD INNER LH |
![]() |
Remove the screw.
Detach the 2 claws and clip, and then remove the cushion shield.
| 7. REMOVE FRONT SEAT HEADREST SUPPORT |
![]() |
Remove the 3 hog rings.
![]() |
Detach the hooks.
![]() |
Remove the 2 hog rings and seatback cover wires.
![]() |
Detach the 4 claws and remove the 2 headrest supports.
| 8. REMOVE SEATBACK COVER WITH PAD |
![]() |
Lift the seatback cover and remove the nut and seatback cover bracket from the seat frame.
Lift the seatback cover and remove the 4 hog rings and seatback cover with pad.
| 9. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (w/ Climate Control Seat System) |
![]() |
Disconnect the connector and detach the 2 clamps.
![]() |
Remove the 4 springs.
Detach the 4 hooks and remove the seatback spring.
![]() |
Disconnect the connector.
Remove the 2 screws and lumbar support adjuster.
![]() |
Detach the 3 claws and remove the bush from the seat frame.
| 10. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (w/o Climate Control Seat System) |
![]() |
Remove the 2 springs.
Detach the 6 hooks and remove the seatback spring.
![]() |
Disconnect the connector.
Remove the 2 screws and lumbar support adjuster.
![]() |
Detach the 3 claws and remove the bush from the seat frame.