Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SYSTEM

SLIDING ROOF SYSTEM > TERMINALS OF ECU

for Preparation Click here



SLIDING ROOF DRIVE GEAR (SLIDING ROOF ECU)
B254463E01
  1. Disconnect the U3 ECU connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    U3-1 (UP) - Body ground
    LG - Body ground
    Sliding roof switch signal
    TILT switch is pressed to up
    Below 1 Ω
    U3-1 (UP) - Body ground
    LG - Body ground
    Sliding roof switch signal
    TILT switch is not pressed to up
    10 kΩ or higher
    U3-2 (DWN) - Body ground
    W - Body ground
    Sliding roof switch signal
    TILT switch is pressed to down
    Below 1 Ω
    U3-2 (DWN) - Body ground
    W - Body ground
    Sliding roof switch signal
    TILT switch is not pressed to down
    10 kΩ or higher
    U3-6 (OPN) - Body ground
    BE - Body ground
    Sliding roof switch signal
    SLIDE switch is pressed to open
    Below 1 Ω
    U3-6 (OPN) - Body ground
    BE - Body ground
    Sliding roof switch signal
    SLIDE switch is not pressed to open
    10 kΩ or higher
    U3-7 (CLS) - Body ground
    V - Body ground
    Sliding roof switch signal
    SLIDE switch is pressed to close
    Below 1 Ω
    U3-7 (CLS) - Body ground
    V - Body ground
    Sliding roof switch signal
    SLIDE switch is not pressed to close
    10 kΩ or higher
    U3-8 (E) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    U3-9 (IG) - Body ground
    SB - Body ground
    IG power supply
    Ignition switch ON
    11 to 14 V
    U3-9 (IG) - Body ground
    SB - Body ground
    IG power supply
    Ignition switch off
    Below 1 V
    U3-10 (B) - Body ground
    L - Body ground
    +B power supply
    Always
    11 to 14 V
    If the result is not as specified, there may be a malfunction on the wire harness side.