Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SYSTEM

SLIDING ROOF SYSTEM > Sliding Roof ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof ECU power source circuit.

WIRING DIAGRAM


B171240E04


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (IGNITION SWITCH SIGNAL)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Sliding Roof / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Sliding Roof 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Ignition (Direct Signal)
    Ignition switch signal/ON or OFF
    ON: Ignition switch ON
    OFF: Ignition switch off
    -
    Ignition (MPX)
    Ignition switch signal (MPX signal)/ON or OFF
    ON: Ignition switch ON
    OFF: Ignition switch off
    -

    OK:
    The intelligent tester displays as shown in the table according to the operation of each switch.



NG
Go to step 2
OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (Click here)  

2.INSPECT FUSE (S/ROOF, ECU-IG No. 1)


    B188612E01
  1. Remove the S/ROOF and ECU-IG No. 1 fuses from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S/ROOF fuse
    Always
    Below 1 Ω
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


3.CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - BATTERY AND BODY GROUND)


    B130117E17
  1. Disconnect the U3 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage :
    Tester Connection
    Switch Condition
    Specified Condition
    U3-9 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V
    U3-10 (B) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U3-8 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (Click here)