AIR SWITCHING VALVE (w/ Secondary Air Injection System) > INSPECTION |
| 1. INSPECT ELECTRIC AIR CONTROL VALVE ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 5 | 20°C (68°F)* | 4.5 to 5.5 Ω |
| 1 - Body ground | Always | 1 MΩ or higher |
| 5 - Body ground |
![]() |
Check the operation of the electric air control valve assembly.
Check that air does not flow from port A to port B.
![]() |
Apply battery voltage to the connector, and check the electric air control valve operation.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 5 | Air flows from port A to port B |