Home › Engine / Hybrid System › 3UR-FE EMISSION CONTROL › AIR PUMP (w/ Secondary Air Injection System)

AIR PUMP (w/ Secondary Air Injection System) > REMOVAL

for Preparation Click here



1. SEPARATE FRONT FENDER LINER RH


    A184974
  1. Remove the 8 clips, separate the fender liner.



2. SEPARATE FRONT FENDER APRON SEAL RH


    A153461
  1. Using a clip remover, separate the 2 clips and fold back the fender apron seal.



3. REMOVE NO. 2 AIR INJECTION SYSTEM HOSE


    A158592E01
  1. Engine Room Side:

    1. Disconnect the 2 clamps.

    2. Disconnect the No. 2 air injection system hose.

    3. Using a clip remover, remove the clamp from the body panel.

  1. Front Fender RH Inside:

    1. Disconnect the clamp.

    2. Disconnect the No. 2 air injection system hose from the air pump.



4. REMOVE NO. 3 AIR INJECTION SYSTEM HOSE


    A158593E02
  1. Engine Room Side:

    1. Disconnect the clamp and No. 3 air injection system hose.

    2. Using a clip remover, remove the clamp from the body panel.

  1. Front Fender RH Inside:

    1. Disconnect the No. 3 air injection system hose from the air pump.

    2. Using a clip remover, remove the clamp from the body panel.



5. REMOVE AIR PUMP ASSEMBLY WITH BRACKET


    A184975
  1. Disconnect the 2 air pump connectors and detach the 3 wire harness claws.



    A158659
  1. Remove the 2 bolts, 2 nuts and air pump.



6. REMOVE AIR PUMP INLET


    A209975E01
  1. Remove the 2 bolts, disconnect the 2 hoses and remove the air pump inlet.



7. DISCONNECT NO. 1 AIR INJECTION SYSTEM HOSE
  1. Disconnect the 2 No. 1 air injection system hoses.



8. REMOVE AIR PUMP ASSEMBLY


    A153467
  1. Using a clip remover, detach the 2 wire harness clamps and remove the 2 air pump assemblies from the bracket.

  1. Disconnect the 6 air pump insulators.