Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH

CLEARANCE SONAR MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT DRIVE MONITOR SWITCH


  1. Check the resistance.



      E147261E01
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      7 (IG) - 8 (SK)
      Sonar switch off
      10 kΩ or higher
      Sonar switch on
      Below 1 Ω

      If the result is not as specified, replace the drive monitor switch.

  1. Inspect the illumination operation.

    1. Apply battery voltage to the drive monitor switch connector and check that the illumination illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1 (ILL+)
      Battery negative (-) → Terminal 6 (ILL-)
      Illumination illuminates

      If the result is not as specified, replace the drive monitor switch.